RiSER SERviciNG ANd AdjUSTMENTS
Caution!
the riser assembly is under spring tension. eye protection should be worn and safe-handling procedures
followed when servicing this product.
tools needed (varies with riser model)
• T-Handle Tool – PN 319100
• Hunter Wrench – PN 471720
• Snap-ring Tool – PN 251000
• Needle-Nose Pliers
• Flat Blade Screwdriver
• Phillips Screwdriver
uPPeR SnAP-Ring ReMoVAl – g800 SeRieS
Hold snap-ring tool vertical over the rotor’s upper snap ring. align the metal end of the snap-ring tool to the
indicator on the snap-ring’s rubberized wiper seal (fig 7). use the palm of the other hand to drive the tool downward
& through the rubberized membrane. tool should penetrate about ½ inch into the snap-ring assembly (fig 8). While
holding the tool within the snap-ring, press the tool’s handle downward and away from the center of the rotor. as the
tool is pressed downward, the snap-ring will lift from the rotor (fig 9). While using the tool to hold the snap-ring in
this elevated position, use the other hand to pull the snap-ring from the rotor. If the snap-ring’s rubberized wiper seal
appears to be the only part that is lifting, the tool has not penetrated into the snap-ring far enough.
FIg 7
FIg 8
FIg 9
7
Summary of Contents for G835
Page 2: ......
Page 21: ...Fig 47 Fig 49 Fig 50 Fig 48 Fig 48 Fig 47 Fig 48 Fig 47 18...
Page 57: ...54...
