Hunter ET System, Owner'S Manual

Page: 10 / 36

AC AC R RS C MV 1 2 3 4 5 6
9 V Battery
RESET
Blue Red
White
Blue Red
White
Blue
Red
White
8
Sensor with appropriately sized butt splices or wire nuts. These two
wires may be extended up to 100 ft./30m to reach the sensor.
SRC or SRC
Plus Controller
Connection
If no wireless
remote control
receiver will be
installed, the
Orange wire
(or Blue-And-
White-Striped
wire in some
versions) from
the ET Module
is not used.
Connect the red wire from the ET Module to the bottom left of the two
terminals on the power module labeled “24VAC” (or just AC, on older
units).
Connect the white wire from the
ET Module to the second to the
right of the two terminals on the
power module labeled “24VAC” (or
just AC, on older units)..
Connect the blue wire from the
ET Module to the terminal in the
controller labeled “R”.
If no wireless remote control
receiver will be installed, the blue-
and-white striped wire from the ET
Module is not used.
Pro-C Controller Connection
Connect the red wire from the ET
Module to the terminal in the controller labeled AC1.
Connect the white wire from the ET Module to the terminal in the
controller labeled AC2.
Connect the blue wire from the ET Module to the terminal in the con-
troller labeled REM.
ICC Controller Connection
Connect the red wire from the ET Module to the bottommost of the
terminals on the power module labeled “AC”.
Connect the white wire from the ET Module to the upper of the two
terminals on the power module labeled “AC”.
Connect the blue wire from the ET Module to the terminal in the con-
troller labeled REM.