9
When powered up, the Com module display will show the version number,
and will automatically check to see what other communications devices are
installed.
Overview:
1. Address the Com module
2. Obtain data for the Cellular Activation form
3. Obtain CID number from Com module
4. Contact Hunter Technical Support (in USA) for network activation
After a few moments, the display will show “ACC-COM-LTE” or a single
controller version will show “ACC-P2P-LTE.”
When the device has connected to the cellular carrier, a flashing block will
appear in the upper right corner of the Com module display.
When the device has detected LTE service, the flashing block will show a
letter “C.”
The device is ready for central communications when the C appears.
Com Module Controls
The Com module controls use the up and down arrow buttons to make
selections, a + and – button to change individual settings, and an Enter key
(far right) to select and/or save settings.
To Set the Controller Address
The controller ID, or address, is required before any communications can
take place. An address must be any number between 1 and 999.
Press the Up arrow once. The display will show Controller Address. The
address will be 000 if the module is new. The address must be set to a valid
number before the module will communicate.
Press Enter to enter the address edit mode. The address number will blink.
You can use the left and right arrow buttons to move through each of the
three number fields.
Use the + or – buttons to change the address to the desired setting. If you
Setup and Addressing of the Com Module
Summary of Contents for ACC-COM-LTE
Page 15: ...15 Notes ...
