8
Installation Instructions
(Attaching an accessory light kit)
Electrician
Installation Manual
Majestic Everglade Ceiling Fan
STEP 1 (Fig. 10)
a)
Use your thumb to push out the plug in the pull cord
assembly kit, see figure 10.
NOTE: These instructions follow from step 8a of the ‘Assembling the Fan section’ on page 7
Pull Cord
Assembly Kit
Fig. 10
STEP 2 (Fig. 11)
a)
Loosen and remove the light kit
screws to separate the top cover from
the lower part of the light kit.
b)
Feed light wires from pull cord
through thread and into the light kit.
c)
Attach the light kit to pull cord
assembly kit by tightening the thread
clockwise as shown in figure 11.
d)
Connect light wires to terminal block
in lower part of the light kit.
e)
Reattach lower part of the light kit to
the top cover of the light kit using the
three screws removed from step 2a).
Plug
Pull Cord
Assembly Kt
Light Kit
Screw
Light
Wires
Terminal Block
Thread
Top Cover
of Light Kit
Lower Part
of Light Kit
Fig. 11
1.
Do not
attempt to operate the fan (or optional light kit) with any wall control that is
not approved by Hunter Pacific for use with its fans. DO NOT use solid state
controllers. The use of unapproved controllers will void your warranty.
2.
Do not
mix blade sets from one fan to another as this may upset the balance of
the fan. If only one blade is damaged you are still required to replace with a new set.
