5
STEP 3 (Fig. 3)
a)
Hang the ball joint into the hanger bracket. Ensure the groove on the
hanger bracket is locked into the slot on the ball joint. (This is important
to ensure the fan will not wobble and the weight of the fan is supported).
1.
Do not
attempt to operate the fan (or optional light kit) with any wall control that is
not approved by Hunter Pacific for use with its fans. DO NOT use solid state
controllers. The use of unapproved controllers will void your warranty.
2.
Do not
mix blade sets from one fan to another as this may upset the balance of
the fan. If only one blade is damaged you are still required to replace with a new set.
Installation Instructions
(Assembling the fan)
Electrician
Installation Manual
Majestic Everglade Ceiling Fan
Fig. 2
STEP 2 (Fig. 2)
a)
Drill a hole in the timber nogging for wiring.
b)
Secure the hanger bracket onto the timber
nogging, using the two hex head screws
provided. The timber nogging should be
supplied by the installing electrician and must
be supported between the two ceiling joists as
shown in the diagram above.
STEP 1 (Fig. 1)
ONLY PERFORM THIS STEP IF FAN WIRES
HAVE NOT BEEN FED THROUGH DOWN ROD.
a)
Loosen the ball joint screw and remove the
ball joint pin to separate the down rod from the
ball joint.
b)
Feed wires from motor housing up and
through the down rod.
c)
Insert the cotter pin through the connection
collar and the down rod (avoid pinching wires).
Then lock the down rod using the cotter key
and washer. Secure down rod with the two
down rod screws provided.
d)
Slide on canopy cover and refit the ball joint.
e) If extensions rods need to be installed,
please go to page 10.
Fig. 1
Ball Joint
Canopy
Cover
Cotter
Washer
Down
Rod
Screw
Connection Collar
Cotter Key
Cotter Pin
Motor Housing Cap
Hanger
Bracket
Down Rod
Timber Nogging
Hex Head Screw
Hanger
Bracket
