7
STEP 7 (Fig 8)
a)
Attach blade holders to the motor housing
(blades should already be attached).
Installation Instructions
(Assembling the fan )
Electrician
Installation Manual
Majestic Everglade Ceiling Fan
Blade
Screw
Blade
Blade Holder
Base of
Motor Housing
Nine Pin Plug
Connectors.
Pull Cord
Screw
STEP 5 (Fig 6)
a)
Slide canopy cover up and over the hanger bracket.
b)
Twist canopy cover as shown in diagram until the
screws holes can be seen.
c)
Half loosen canopy cover screws.
d)
Now twist canopy cover in the opposite direction to
the diagram and fully tighten the canopy covers screws,
this will stabilise the canopy cover.
Hanger
Bracket
Canopy Cover
Canopy Cover
Screws
Fig. 6
Motor Housing
Blade Holder Screw
Blade with
Holder attached
STEP 6 (Fig 7)
a)
Attach blades on to the blade holders as
shown in figure 7.
Fig. 7
Fig. 8
STEP 8 (Fig 9)
a)
Unscrew the pull cord screws to
separate the pull cord assembly kit from
the motor housing.
(If you are attaching
a light kit go to page 8).
b)
Make sure the two ends of the nine
pin plug are connected together and the
colours on the plugs are corresponding.
c)
Use pull cord screws to re-secure the
pull cord assembly kit to the motor
housing.
d)
Attach the pull cord handle to the pull
cord chain.
Fig. 9
Blade
Washer
Pull Cord
Assembly Kit
1.
Do not
attempt to operate the fan (or optional light kit) with any wall control that is
not approved by Hunter Pacific for use with its fans. DO NOT use solid state
controllers. The use of unapproved controllers will void your warranty.
2.
Do not
mix blade sets from one fan to another as this may upset the balance of
the fan. If only one blade is damaged you are still required to replace with a new set.
