INSTALLATION
5
■
Mark the location of the screw holes.
➤
The minimum depth required for mounting is 2"
with a battery wand and a back cover.
➤
Minimum depth is 1
1
/
4
"
with a satellite battery
pack or 18V DC power supply and back cover.
➤
The depth required for fully recessed mounting
will vary depending on the type of headrail and
vane size. Refer to the chart below for depth
requirements.
IMPORTANT:
The front edges of the installation brackets must be level and aligned.
WARNING:
Failure to properly align the brackets could result in the headrail
releasing from the brackets.
■
Drill the screw holes using a
3
/
32
" drill bit.
CAUTION:
Use drywall anchors when mounting into drywall.
■
Use a level to check that the mounting surface is level. If
necessary, you can shim the brackets using the top tabs that
were removed from the brackets.
■
Attach the installation brackets using the screws provided.
IMPORTANT:
Do not overtighten the screws. Check to
ensure the lever can be moved easily side to side. If not,
loosen the screws in one-eighth turn increments until the
lever can be moved easily.
■
If using the optional back cover:
Install the cover into
the back cover brackets. If necessary, trim the back cover
to the desired width.
IMPORTANT:
If using a battery wand, do not install the
optional back cover until the wand is installed (see Battery
Wand on page 10).
Proceed to “STEP 2 — Mount the Battery Wand and Connect the Power Cable, If Applicable”
on page 10.
Fully Recessed
Mounting Depths
Classic
Headrail
Quartette
®
4"
Headrail
Battery Wand & Back Cover
4
1
/
16
"
4
9
/
16
"
Satellite Battery Pack or DC Power
Supply & Back Cover
3
1
/
2
"
4"
Minimum
Depth
2" Battery Wand
1
1
/
4
" Battery Pack or
18V DC Power Supply
2"
Back
Cover
