OPERATION
16
Testing the Shading
Use the programming button to test the shading and
ensure that the motor and power source are working
correctly.
■
Press the programming button to lower the
shading. If the shading does not operate, see
“Troubleshooting” on page 20.
■
Test vane operation by pressing the
programming button to open the vanes and then
pressing it again to close the vanes.
■
After the vanes are fully closed, press the
programming button to raise the shading.
CAUTION:
When raising the shading for the first time, observe how the fabric rolls up into
the headrail. It should roll up evenly. If the bottom rail is not level or the shading starts to rub
against either window jamb, immediately press the programming button to stop the shading.
See “Adjust the Bottom Rail Weight” on page 23.
Using the PowerView
®
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT:
If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
®
Shade Network” in the
PowerView Motorization Remote Control Guide
.
Group 1
Group 2
OPEN
CLOSE
Group 3
Group 4
Group 5
Group 6
Favorite
(Shading/vane position)
LEFT ARROW
Tilts vanes closed
RIGHT ARROW
Tilts vanes open
STOP
(Press and hold for
programming mode)
