INSTALLATION
10
STEP 3: Install the Shading
Install the Optional Back Cover (If Applicable)
The optional back cover is used on inside and end mounts only.
■
Install the back cover into the back cover brackets on the rear of the installation brackets, as
shown. If necessary, trim the back cover to the desired width.
➤
On shadings with battery wand(s), the top of the back cover fits onto the top tab of the
back cover bracket.
IMPORTANT:
If using a battery wand, do not install the optional back cover until the
wand is installed. Refer to “STEP 2: Mount the Battery Wand and Connect the Power
Cable” on page 9.
➤
On all other shadings, the top tab has been removed and installs closer to the installation
bracket.
Mount the Headrail
■
Peel back the protective covering from the top of the fabric-covered headrail. Leave the rest
of the protective covering on the front of the headrail.
■
Position the shading so that the front faces you.
■
Slide the headrail into the installation
brackets so the edge of the headrail
is between the lever and the bracket,
as shown.
■
Firmly push the headrail into each bracket until it clicks and the
lever snaps to the right side of the bracket.
IMPORTANT:
Carefully pull on the headrail at each bracket to ensure it is
installed securely.
■
Completely remove the protective covering from the fabric-covered headrail.
Headrail
Installation
Bracket
Lever
Slide the Headrail
Between the Lever
and the Bracket
Back
Cover
Back
Cover
