Hunter Douglas ALPHA Series, Installation And Measuring Manuallines

Page: 16 / 52

Page 14
INTERNAL TAPE WINCH INSTALL INSTRUCTIONS
Page 19
ALPHA SERIES INSTALLATION MANUAL
INTERNAL TAPE WINCH INSTALL INSTRUCTIONS
Fitting Internal Tape Winch
- Unscrew the cover of the internal tape winch and note the direction in which the tape runs off the spool.
- Remove the tape supplied with the winch.
- Thread the tape from the awning tape spool through the two swivel tape guides. Attach swivel tape guides to the
internal and external walls. Lower the awning.
- Thread the end of the tape through the slot on the tape winch spool. Cut the tape so that only 1 - 2 windings will
remain on the spool. Tie a secure knot in the end. Wind the excess tape on to the spool. Replace the spool in the winch
ensuring that the tape winds off in the correct direction. Screw cover back on to winch.
- Drill four (4) holes in the wall for the winch and fit rawl plugs supplied or use the fastener appropriate for the
installation. At least two of the screws should be set into an architrave or stud. All four screws must be used. If
necessary add packing behind the winch if attaching to an uneven surface.
- Test the awning to see if it functions properly.
Page 19
ALPHA SERIES INSTALLATION MANUAL
INTERNAL TAPE WINCH INSTALL INSTRUCTIONS
Fitting Internal Tape Winch
- Unscrew the cover of the internal tape winch and note the direction in which the tape runs off the spool.
- Remove the tape supplied with the winch.
- Thread the tape from the awning tape spool through the two swivel tape guides. Attach swivel tape guides to the
internal and external walls. Lower the awning.
- Thread the end of the tape through the slot on the tape winch spool. Cut the tape so that only 1 - 2 windings will
remain on the spool. Tie a secure knot in the end. Wind the excess tape on to the spool. Replace the spool in the winch
ensuring that the tape winds off in the correct direction. Screw cover back on to winch.
- Drill four (4) holes in the wall for the winch and fit rawl plugs supplied or use the fastener appropriate for the
installation. At least two of the screws should be set into an architrave or stud. All four screws must be used. If
necessary add packing behind the winch if attaching to an uneven surface.
- Test the awning to see if it functions properly.
Fitting Internal Tape Winch
- Unscrew the cover of the internal tape winch and note the direction in which the tape runs off the spool.
- Remove the tape supplied with the winch.
- Thread the tape from the awning tape spool through the two swivel tape guides. Attach swivel tape guides to the
internal and external walls. Lower the awning.
- Thread the end of the tape through the slot on the tape winch spool. Cut the tape so that only 1 - 2 windings will
remain on the spool. Tie a secure knot in the end. Wind the excess tape on to the spool. Replace the spool in the
winch ensuring that the tape winds off in the correct direction. Screw cover back on to winch.
- Drill four (4) holes in the wall for the winch and fit rawl plugs supplied or use the fastener appropriate for the
installation. At least two of the screws should be set into an architrave or stud. All four screws must be used. If
necessary add packing behind the winch if attaching to an uneven surface.
- Test the awning to see if it functions properly.
ALPHA AWNING SERIES INSTALLATION MANUAL