Page 28
STEP 9 - ATTACHING THE FRONT COVER
a) Raise skin so bottom rail is within 100mm of top end cap.
b) Align front cover on back plate so face is flush with side
channel outer surface then slide into position.
c) Fasten the front cover into position by fixing the
screws with a screwdriver through the front cover
at the top of the bottom end caps.
Fixing screws (12mm)
Fixing screw (12mm)
STEP 7 - TEST AND ADJUSTMENT
a. Run the awning up and down a
few times to assess it is running
smoothly and does not catch.
b. Where there is any tightness /
catch points adjust the positioning
of the fasteners at the nearest /
relevant cut outs to either move
the floating channel in or out.
Here it is best to redrill a new pilot
hole in the floating guide above or
below the original one.
c. Check and adjust the top endcap
locating nut to ensure the skin is
rolling square.
STEP 8 - ATTACHING THE FRONT COVER SIDE CHANNEL
a. Raise the skin so the bottom rail is
within 100mm of top end cap.
b. Align the front cover on back plate
so the leading face is flush with
side channel outer surface then
slide into position.
c. Fasten the front cover into position
by fixing screws with a screw
driver through front cover of the
top and bottom end caps.
ALPHA
AWNING SERIES INSTALLATION MANUAL
Summary of Contents for ALPHA Series
Page 1: ...11 2019 ALPHA AWNING SERIES INSTALLATION AND MEASURING GUIDELINES INCLUDES THE SRS V2 ...
Page 51: ...Page 49 ...
Page 52: ......
