Hunt Graphics IMAGE 410, User Manual

Page: 8 / 29

- 8 -
3
H
CONTROL PANEL
1. Power Standby Button turns the power on and off. If
an emergency stop is depressed to cease operation,
the emergency stop button must be reset. Then the
power switch can be depressed to begin operation.
n
Power Indicator Light is on when the laminator is on.
*
Warning! Even when the power is off the laminator
is on Standby. Authorized Service Technicians must
unplug the laminator before any servicing.
2. Motor Button turns the motor on and off. While the
motor is off the footswitch may be utilized. The
footswitch runs in slow mode at 2 feet or .6 meters
per minute.
3. Motor Speed Buttons increase or decrease the speed
of the motor.
4. Motor Speed readout indicates speed in feet per
minute or meters per minute.
n
Motor Indicator Light is lit when motor is on.
5. Top Heater Temperature readout indicates the
current temperature of the top main roll.
6. Top Heater Power Button turns the top heater on or
off.
n
Top Heater Indicator Light is lit when top heater is on.
7. Top Heater Temperature Adjust Button.
n
Push either arrow (up or down) once to see top
temperature set point. Push and hold either arrow to
raise or lower temperature.
8. Bottom Heater Temperature Readout indicates the
current temperature of the bottom main roll.
9. Bottom Heater Power Button turns the bottom heater
on or off.
12
15
1
16
2
6
9
11
14
13
3
4
7
5
10
8