Hunt Graphics IMAGE 410, User Manual

Page: 13 / 29

- 13 -
3
H
LOADING FILM
Each laminating/mounting procedure section, has web
diagrams depicting the correct way to load film.
Seal encapsulating films are wound with the adhesive
side on the inside, as in Figure A.
n
The top and bottom unwind positions are to be loaded
as shown in Figure A.
n
Center the rolls in relation to each other by unwinding
enough material from the top roller to reach the
bottom roll of film. Pull the film straight, then move
the bottom roll of film until the edges line up. See
figure B.
*
Warning! If you choose to use a leader board to
push the film through the nips while webbing:
n
Set the nip to the leader board thickness.
n
After the board passes through the main rollers, you
may set the nip to 0.
n
Failure to do so will cause the machine to register an
error and shut down. To reset, use the door
disconnect.
Figure A
Laminate Side
Adhesive Side
Figure B
Stretch film tight
and align edges.