motors start. Push the throttle stick (default American Hand) up over midpoint to takeoff.
Landing
Pull the throttle stick down until the aircraft touches the ground. There are two ways to stop the motor.
First, after landing, the motors of aircraft are in idle status, if no operation within 3 second, the motors will automatically lock.
Second, after landing, the motor will stop immediately if you execute Combination Stick Command.
Warning
l
During flight, don
’
t performance Combination Stick Command unless in emergency situations, otherwise the aircraft will crash.
l
You can
’
t takeoff if the critical low voltage warning is active.
l
Once spinning, the rotating propellers can be dangerous. Do not start the motors when there are people nearby and always fly in a
wide-open area.
l
Power off the aircraft before switching off the remote controller after landing.
l
Return to Home Function
One Key to Return
Press and hold the Return to Home Button on remote controller or the key in GLINT 2.0 APP interface, the aircraft will automatically return.
If you use the key on remote controller, you can long press the key again to stop the return action. While using APP to return, you should
use S1 function mode switch to change the mode for terminating the return action.
Low Voltage Return to Home
The GLINT 2.0 APP will warn you to performance the return action if the intelligent flight battery level falls under a
certain level.
Failsafe
If the signal to the remote control is lost, the Flight control system will automatically control the aircraft to land or
return.
