13
2. Place the two ratchets, one on either side of
the transducer knuckle, so that the beads on
each ratchet line up with the desired position
number on the knuckle (Figure 18a). If you are
setting the ratchets at position 1, the beads
on each ratchet will line up with the rib on the
transducer knuckle to form one continuous
line on the assembly (Figure 18b).
NOTE:
The ratchets are keyed. Make sure that the square
teeth on each ratchet face the square teeth on the
transducer knuckle, and the triangular teeth face
outward.
Hold the ratchets on the transducer knuckle with one hand and fit the
mounting bracket over them until it snaps into place with the other hand. Refer
to the illustration (Figure 18d).
Measuring the Transom Angle
Measured Distance (X)
Figure 17
Plumb
Line
Transom
Angle in
degrees
(°)
Weight
Transducer Knuckle Positions
Knuckle
Figure 18a
Ratchets Placed in Position 1
Rib at
position 1
Figure 18b
Ratchets Placed in Position 2
Figure 18c
Bead
Ratchet
Rib
Fitting the Mounting Bracket Over the Ratchet
Figure 18d
Beads
Ratchet
Transom Transducer Installation
