4. Route the Control Head Cables Under the Deck
Use the following steps to route the control head cables under the deck.
NOTE:
Under the deck cable routing is not always possible. If this is not an option, the
cables should be routed and secured above deck.
Tilt and Swivel Mount:
1a. Mark and drill a 3/4" hole as shown
in Figure 6. Route the cables
through the hole. The cables will
exit through the center hole on the
control head base.
1b. If the cables cannot be routed
directly beneath the control head
base, mark and drill a 3/4" hole that
will allow you to run the cables
close to the control head base.
Figure 6
3/4”
19 mm
Tilt and Swivel Mount
Control Head Base
NOTE:
See
Transom Transducer Installation
in order to plan the location of the
transducer and cable route.
5
Fixed Control Head Installation
