4
1. Locating the HDR 610 Mounting Position
You must select an appropriate mounting location for the HDR 610. Consider different
positions on the console or deck of the boat. Remember that the cables for the
transducer and power must reach the mounting location. Extension cables are available.
The mounting surface should be visible to the boat operator and adequately supported
to protect the HDR 610 from excessive wave shock and vibration. Allow at least 2"
clearance at the back, sides, and top of the unit for connection, air flow, and ease of
installation and removal.
2. Cutting the Mounting Hole
Once you have selected your mounting location, perform the following steps:
1. Mark the desired mounting location, then drill a pilot hole.
2. Drill a 2 1/8" diameter hole using a hole saw and hand drill. This is a standard hole
saw readily available for rental or purchase. If you prefer, any marine service shop
can perform this task.
3. Customizing and Assembling the HDR 610
Your HDR 610 comes with both black and white bezels, and both black and white
overlays. You must select one color for the bezel, and another color for the overlay, and
perform the following assembly steps:
1. Peel off the protective backing from the overlay, being careful not to let the
adhesive touch anything prematurely.
