QUICK ST
AR
T GUIDE
2
Unpacking
Initial inspection should include checking for physical dam-
age during shipping and obvious external damage to the
product.
Package contents are defined by your packing list. Each
Order is configured according to customer specifications.
In your inspection, make certain that the contents of your
shipment match the documentation provided by your pack-
ing list.
Place unit on a flat, smooth surface and use leveling feet
(supplied) and a bubble level to ensure that the unit is level
side-to-side and back-to-front.
Installation and Equipment Setup
Electrical Connections
The HM-5250 is equipped with an internal digital switching
power supply, which allows it to be used with most power
configurations throughout the world. The unit is supplied
with an IEC electrical cord with a standard 110V plug.
The HM-5250 arrives ready for operation. Attach the sup-
plied IEC electrical cord to the machine and plug into a
standard wall receptacle for use in the United States. For
locations other than the U.S., replace the supplied electrical
cord with an IEC cord that has the correct plug for your ap-
plication. The supplied cord can also be used by cutting the
standard plug from the cord and attaching the correct plug.
Power Switch
The Power Switch is located above the electrical cord inlet.
The Fuse Compartment is located between the electrical
cord inlet and the Power Switch. The HM-5250 uses a 8.5
amp fuse. To begin operation, attach the supplied electrical
cord, plug it in and press the Power Switch.
Fig. 1 Power Switch
Fuse Compartment
Summary of Contents for HM-5250.3F
