20
To assign a test to the selected channel, press the corresponding function
key to the test you wish to select. Pressing a key will toggle between “Y”
and “N”. For example, press
to choose Marshall Test, which will
change the “N” to a “Y” next to Marshall. This would indicate that the
channel selected would be set up to run Marshall Test.
NOTE:
Multiple tests can be assigned to a single channel, however, multiple
channels of the same category cannot be assigned to the same test.
Example:
If channel 1 is configured with a 10,000 lb (50KN) load cell, and
channel 2 is configured with a 5,000 lb (25KN) load cell, it is possible to use
either channel to perform a Marshall test. However, only one of the channels
can be used as the load channel (Stability channel).
To return to any prior screen you can always press
Press
(ENGINEERING SETUP). You should see this screen:
Press
(CONFIGURATION) You will be asked for a password, enter:
You should see this screen:
Press
(SELECT CHANNEL) to scroll through and choose the channel
you wish to configure test for. Once you have selected a channel press
(CONFIGURE TEST). You should see this screen:
* CONFIGURATION
* CALIBRATION
* LOGGING INTERVAL
CONFIGURATION screen
* SELECT CHANNEL “CH1”
* CONFIGURE CHANNEL
* CONFIGURE TEST
* CBR/LBR TEST
N
* MARSHALL TEST
N
* USER DEFINED
N
