Huepar DT03CG, User Manual, Page: 5 / 100

Pulse Mode enables line lasers to be used even in
unfavorable light conditions. The laser lines pulsate at a
high frequency and this can be picked up by special laser receivers
over long distances.
-4-
Safety Instructions
Please read thoroughly and comply with the Safety Instructions and
User Manual before using this product. Failure to read and follow may
void the warranty.
This document must be kept in a safe place and if the laser unit is
passed on, this document must be passed on with it.
WARNING!
CLASS Ⅱ LASER PRODUCT
COMPLIES WITH CFR 1040.10 AND 1040.11
Max. Power Output: <1mW
Wavelength: 505nm-660nm
LASER RADIATION:
DO NOT STARE INTO BEAM.
DO NOT DIRECT EYE EXPOSURE.
AVOID VIEW WITH OPTICAL INSTRUMENTS.
IEC/EN60825-1: 2014
Read all instructions prior to operating this laser tool. Do not remove
any labels from tool.
ATTENTION:
• While the product is in operation, be careful not to expose your eyes
to the emitting laser beam (Green/Red light source). Exposure to a
laser beam for an extended time may be hazardous to your eyes.
• Do not attempt to view the laser beam through optical tools such as
telescopes as serious eye injury may result.
• Do not disassemble or modify the laser in any way. Modifying the tool
may result in hazardous Laser Radiation Exposure.
• An exposure to the beam of a Class 2 laser is considered safe for a
maximum of 2 seconds. Eyelid reflexes will normally provide adequate
protection.