Huepar DT03CG, User Manual, Page: 13 / 100

Note:
！
• To restore horizontal or vertical leveling, deactivate the slope
function.
• The automatic sensor is deactivated under slope function.
• Under Slope Function Mode, the laser beam(s) will blink about
every 3-5 seconds to notify the user it is not self-leveling now.
• For the slope function, laser lines are no longer aligned to the
horizontal or vertical plane. This is a specific feature of adjusted
laser lines.
2. Vertical adjustment up to a max. of 3.5° :
Step 1: Short press to turn off the horizontal line. Then short
press button to switch on the front vertical laser line.
3. Turn OFF the slope function
• Method 1: Press and hold the button for ≥3 second until the
slope function LED (18) lights off. It will return to the self-leveling mode.
•
Method 2: Short press to turn OFF the laser unit and power ON
again. It will return to the self-leveling mode.
Step 3: Keeping pressing and holding the or button to adjust
slope. When the lasers blink, the maximum slope range (3.5°) has
been reached.
-12-
Step 2: Press and hold button for ≥3 seconds until the slope
function LED
（
18
）
flashes rapidly . Motor-driven adjustment of the
slope is now enabled.
3 sec.