Huepar DT03CG, User Manual

Page: 15 / 100

Note:
！
• Read the operating instructions of the laser receiver for line
lasers thoroughly.
• The laser beam is dimmer in pulse mode than the brightest
laser beam in self-leveling mode.(Please refer to the
Brightness Adjustment Function part)
• It is necessary to turn on the pulse mode when use with a
receiver.
• Due to the special optics required to generate a continuous
360° laser line, the underlying technology may cause
differences in brightness of the laser line in different areas. This
may lead to different ranges in pulse mode.
Brightness Adjustment Function
• Step 2: Then press and hold the button for ≥3 seconds to enter
into slope function mode, slope function LED
（
18
）
will flash rapidly
.
B. Pulse mode under Slope function:
• Step 1: Short press to enter into pulse mode, the pulse mode
LED (18) will be always on in green and the laser beams become
dimmer.
Step 1: In self-leveling mode, press and hold the button for ≥3
seconds until the ON/OFF LED (17) lights off to enter into brightness
adjustment.
Step 2: Short press the to enhance the brightness. Short press
the to reduce the brightness.
Step 3: Once the brightness is accepted, users can save the change by
pressing and holding for ≥3 seconds until the ON/OFF LED (17)
lights on again. Now the brightness adjustment function is disabled.
Step 4: Now the laser unit can be operated normally under updated
brightness of the laser lines.
• Step 3: Now the laser unit can be used with the laser receiver under
non-level conditions.
-14-
• The pulse mode LED (18) will be always on in green and the laser
beam becomes dimmer in pulse mode.