3
INTRODUCTION
Thank you for purchasing the Westpoint pellet stove. The Westpoint has been tested and
listed for installation in residential and mobile homes.
This heater has been certified to ASTM E1509-04
Standard Specification for Room
Heaters, Pellet Fuel-Burning Type.
The performance of your pellet stove can be affected by the type of pellet fuel burnt in
the appliance. It is important to use only pellet fuel that is dry and free from dirt or other
impurities.
The Pellet Fuel Industry has established standards for wood pellet manufacturers. It is
recommended that the fuel used in this appliance meet or exceed the following
specifications:
Fines (fine particles)…….1% maximum through a 1/8" screen
Bulk Density…………….minimum 40 lbs per cubic foot
Size……………………...maximum
3/8"
diameter by 1-1/2" long
Ash Content……………..1% maximum (Premium grade)
……………..3% maximum (Standard grade)
Moisture Content………..8% maximum
Heat Content…………….minimum 8,200 btu/hr
It is important to note that the ash content of the fuel (and frequency of operation)
determine the frequency of cleaning required for your unit. A high ash fuel may result in
your unit having to be cleaned daily while a low ash content fuel may permit a longer
time between cleaning.
Occasionally impurities in the fuel will cause a hard mass build up in the burn pot. This
build up may block the air flow through the burn pot affecting the performance of your
unit. Check the burn pot daily for any blockage. If necessary remove the burn pot liner
(once unit has cooled) and clean the liner and the burn pot.
Since Hudson River Stove Works has no control over the quality of pellet fuel used in
this unit they assume no responsibility for the end users choice in wood pellets.
Caution:
Be sure to store the pellet fuel a minimum of 3' (0.9 m) away from the pellet
stove.
Please note that the rating label may be found on the inside of the right hand door.
