14
3/.
Make sure the appliance is within 6’ of a power outlet
4/.
This stove is designed so that no floor pad is required, however we do recommend
installing one.
DO NOT
install your stove directly onto carpeting.
5/.
Place the stove approximately 15” (381 mm) away from the interior wall.
6/.
See the appropriate sections below for continued instructions for your specific
vent requirements.
HORIZONTAL EXHAUST VENT INSTALLATION
7/.
Locate the center of the exhaust pipe and air intake connector of your unit. These
points should then be extended to the interior wall of your house. Once you have
located the center point, on the interior wall, cut a hole in the wall as shown in the
instructions accompanying the wall thimble.
8/.
The next step is to install the wall thimble, refer to the instructions which come
with the wall thimble for this step.
9/. Install
the
appropriate length of exhaust vent pipe into the wall thimble. See step
11 when determining the correct length of exhaust vent to use.
10/.
Install the combustion air intake pipe. The unit is to use outside air for
combustion. Be sure that the outside air vent has a proper cap on it to prevent
rodents from entering and also is installed where it won’t become blocked with
snow, etc..
11/.
Connect the exhaust vent pipe to the exhaust outlet of your appliance.
12/.
Secure all vent joint connections with 3 screws. Seal the exhaust vent joint
connections with high temperature silicone sealant.
13/.
Push the unit straight back to the interior wall but be sure to maintain the
minimum clearances to combustibles 8” (204 mm) to the back of the unit and a
minimum of 9” (229mm) to the sides of the unit. Seal the annular space, of the
wall thimble, around the vent pipe with high temperature silicone sealant.
