This instruction manual must be read
with particular attention to the
following safety guide lines, by any
person servicing or operating this tool.
1. Safety Glossary
W ARNINGS - Must be understood to
avoid severe personal injury.
CAUTIONS - show conditions that will
damage equipment and or structure.
Notes - are reminders of required
procedures.
Bold, Italic type and unerlining -
emphasises a specific instruction.
2. Huck equipment must be maintained in
a safe working condition at all times and
inspected on a regular basis for damage
or wear. Any repair should be done by a
qualified repair person trained on Huck
procedures.
3. Repair person and Operator must read
and understand any Warning and Caution
stickers/labels supplied with equipment
before connecting equipment to any
primary power supply - - as applicable,
each of the sections in this manual have
specific safety, and other information.
4. When repairing or operating Huck
installation equipment always wear
approved eye protection. Where
applicable, refer to ANSI Z87.1 - 1989.
5. Disconnect primary power source
before doing maintenance on Huck
equipment.
6. If any equipment shows signs of
damage, wear or leakage, do not connect
it to the primary power supply.
7. Make sure proper power source is used
at all times.
8. Never remove any safety guards or
pintail deflector.
9. Never install a fastener in free air,
personal injury from fastener ejecting may
occur.
10. Do not abuse tool by dropping or
using it as a hammer. Reasonable care of
installation tools by operators is an
important factor in maintaining tool
efficiency, eliminating downtime and in
preventing an accident which may cause
severe personal injury.
3
Summary of Contents for LH-224
Page 2: ......
