Operating manual HBG 800-DP
Rev. 05 - 08/18
Hubitron Steuerungstechnik
Hubitron Steuerungstechnik, Hauptstr. 4/1, D-89611 Obermarchtal, Germany, Tel. +49(0)7375/922066, FAX +49(0)7375/922077
6 of 16
7.2 Out of operation
Is the hand wheel cut off from the supply voltage for
a longer time period, it is very important to attach
the magnet with an adhesive tape to the hand
terminal. The magnet causes an internal reed
contact to disconnect the supply voltage. This way
damage to the accus is avoided.
For correct placement:
-
push and hold safety buttons – LED's are on.
-
run with the magnet over the right side of the
hand terminal in height of the housing slits until
the LED's turn off.
-
fix the magnet in this position with adhesive
tape.
-
push the safety buttons again, if LED's are off,
the magnet is installed correctly.
8. Operation
8.1 Switching on and off of the hand
terminal
The hand terminal is switched on with one of the
safety buttons (12 or 13).
The connection builds up after both safety
buttons are released again!
The switching off is possible in two ways:
1.
push the emergency stop
2.
return the hand terminal to the charging
station
Remark:
To avoid an accidental emergency stop the hand
terminal has to be turned on with the safety buttons
before you take it out of the charging station! To do
this, simply push one of the safety buttons and
release again.
After enabling the hand wheel on the machine
control it can be used.
The assignment of the buttons and LED's has to be
programmed on the PLC of the machine. An
example programm is available on the support CD.
8.2 LCD display
On the 2 line LCD display error codes and warnings
are displayed.
It is also possible to display user information like
axis information and potentiometer positions....
9. Set up
9.1 Used buttons
For the Set up the following buttons are used:
1
safety buttons to
switch on
2
enable set up
3
enter
4
change values
5
exit set up
9.2 Enter Set up
If you enter the set up, the communication with the
machine is interrupted. This causes an emergency
stop!
1
Turn off hand terminal with the emergency stop
button. Pull emergency stop button!
2
Push and hold both buttons (2)
3
Turn on the hand terminal with a quick push on
the safetyl buttons (1)
The display must show:
SETUP
Power
9.3 Change Set up
In the Set up the following menue points can be
selected:
menue
description
setting range
Power
transmitting power
0 – 7
Kanal
channel setting
0 – 20
Range
range setting
20 – 60
Test-Nr
test functions
0 – 8
o start Set up menue as described in 9.2
o select menue point with b/- (4)
o enter menue point with button X (3)
o change value with b/- (4)
o confirm selection with button X (3)
o exit Set up with button 5
When changing the channel be sure that the access
point is turned on and within range!
