Huberth RP207183-R, User Manual

Page: 8 / 13

POLISHER EN
8
- The tool must be used with accessories that have been specifically designed or recommended by the manufacturer .
The fixing of the accessory to the tool does not guarantee a safe operation.
- The rated speed of the accessories must be at least equivalent to the maximum speed specified on the tool . Using the
accessories at speeds above the rated one, may cause them to break or be projected into the air.
- The external diameter and thickness of the accessories must match the specifications of the tool . Accessories with
incorrect dimensions cannot be adequately protected or controlled.
- The configuration of accessories must match the tool. The use of accessories that cannot be perfectly fitted on the tool
may result in imbalance, excessive vibrations and in the impossibility of controlling the tool.
- Do not use damaged accessories. Before use, inspect all the accessories. Inspect the supporting pads and verify there
are no cracks, tears or excessive wear. If the tool or accessory has fallen, verify that it is not damaged or install a
new accessory. After inspecting or installing an accessory, test the operation of the tool at maximum speed and
without load for one minute, keeping at a safety distance
. If the accessories are damaged, they will break during this
test.
SPECIFTC SAFETY WARNINGS
Verify that no loosened part of the polishing tool shroud or the locking ties can rotate freely. Safely position or cut all the
loosened fixings. Loosened or revolving fixings may twist around the operator’s fingers or get caught by the work piece being
machined.
STARTING UP
Voltage and power frequency must match the data displayed on the identification plate. Make sure that tool is switched
off before plug is connected.
TOOL ASSEMBLY
Screw the side handle ( 3 ). Side handle may be positioned to the right or to the left of the equipment.
ACCESSORIES ASSEMBLY
PLATE PAD HOLDER
Screw pad holder (
5 ) while preventing it from moving or stop movement by enabling lock button ( 1 ).
PAD
Apply pressure on polishing pad to join pad to plate. Use polishing foam and foam support pad up to Ø180 mm.
START AND STOPPING
- Starting: move the switch lever ( 4) up; to lock it in “engaged” position, move the switch block ( 2 ) forward towards the
machine body.
- Stopping: release the switch lever (
4 ); if the switch is in “engaged” position, move the switch lever ( 4 ) up in order to release
the switch block ( 2 ).
The tool continues to rotate after it is turned off.
SELECTING RPM
The rpm can be adjusted by rotating the wheel ( 5 ). The choice of speed depends on the characteristics of the abrasive disc and
the material to be worked.
ACCESSORIES DISASSEMBLY
- Lock the spindle by pressing button ( 1 ), while at the same time rotating the pad until it locks position.
- Dismount the pad.
Never press the button to lock the pad or pas until the tool has stopped moving and is perfectly stationary; the
gear box or the push button pin could be broken and the guarantee would be invalidated.
NOISE EMISSION
Use ear protection!