P
AGE
17
of 28
A
UXILIARY
P
OWERED
ADA-C
OMPLIANT
E
MERGENCY
P
HONES
Pub.
42004-378A
d:\standard ioms - current release\42004 instr. manuals\42004-378a.doc
05/06
For Models 294-101AL, and 298-101, the procedure is as follows:
1.
Disable the password protection feature—insert the
J9
jumper on pins 2 and 1.
2.
Press the
C
ALL
push button. A dial tone is broadcast over the speaker. Simultaneously press
1
and
#
on the phone keypad. The telephone generates a splash tone followed by a success tone.
3.
Enter the desired programmable parameters. See the Programming Sequences section below.
A success tone (single tone [DTMF #]) tone is generated each time a new parameter is accepted. An
error tone (double beep) is generated to indicate an error. If an error tone is generated, verify the
programming sequence is correct, and enter the sequence again.
N
OTES
:
•
The telephone is off-hook during local programming. Therefore, programming should be
completed quickly to avoid any off-hook timeouts controlled by the CO or PBX.
•
The telephone automatically times out if 20 seconds elapse between digit entries.
4.
Terminate the programming by pressing the
C
ALL
push button.
5.
Enable the password protection feature—insert the
J9
jumper on pins 3 and 2.
