Part No...........................................
701 Millennium Blvd • Greenville, SC 29607
With representatives offices in principal cities throughout North America.
Copyright , revision, All Rights Reserved - Printed in U.S.A.
2018 06/26/18
w
w
w
.p
re
s
c
o
lit
e
.c
o
m
•
P
re
s
c
o
lit
e
T
o
ll
F
re
e
T
e
c
h
n
ic
a
l S
u
p
p
o
rt
1
.8
8
8
.P
R
S
.4
T
E
C
•
H
o
u
rs
: 8
a
m
-
5
p
m
E
T
93058101
Page 3 of 8
In
s
tr
u
c
tio
n
S
h
e
e
t
CAM ACTION
RETENSION
MOUNTING PLATE
WITH KEYHOLE SLOTS
(SCREWS DO NOT
HAVE TO BE REMOVED
FROM O.B)
3 1/4" OR 4" O.B.
FIXTURE
ADAPTER
CANOPY SWIVEL
ASSEMBLY
SET SCREW
SET SCREW
MOUNTING
PLATE
MOUNTING
PLATE STUD
SET SCREW
GROUND SCREW
STEM
WALL MOUNT
1. Detach mounting plate from wall bracket by
loosening set screw.
2. Secure mounting plate to outlet box with screws
from outlet box.
3. Hang fixture on mounting plate by the mounting plate
stud.
4. Make electrical connections using properly sized UL
listed wire connectors. Connect the line voltage to
the black wire, the neutral to the white wire, green to
the ground wire and ground screw, and make any
control connections to the proper control wires. Cap
any dimming wires not being used.
5. Lower luminaire until it rests against wall. Lock it in
place by tightening the set screw on bottom of
canopy housing. CAUTION: Do not pinch any wires
between the outlet box and the mounting plate or
any other part of the fixture!
NOTE: In compliance with Underwriters Laboratory
Standard UL 1570, 1571, or 1572; the use of a
silicone base caulking compound must be used to
provide a watertight seal between fixture and
mounting surface to prevent electrical wiring from
getting wet.
PENDANT MOUNT
1. Install Canopy Swivel assembly coupling to top of
threaded stem and secure with set screw.
2. Feed all fixture wires through bottom of stem and
canopy swivel assembly, thread stem to fixture
adapter and secure with set screw.
3. Rotate and slide canopy cover from mounting plate.
4. Align appropriate keyhole slots in mounting plate
with octagonal box (by others) screws and rotate to
lock into place.
5. Make electrical connections using properly sized UL
listed wire connectors. Connect the line voltage to
the black wire, the neutral to the white wire, green to
the ground wire and ground screw, and make any
control connections to the proper control wires. Cap
any dimming wires not being used.
6. Re-attach the canopy.
CANOPY COVER
