Scalable Fixtures (ERS1, ERS2)
Evolve
™
LED Roadway Light
•
This luminaire is designed for outdoor lighting service,
and should not be used in areas of limited ventilation,
or in high ambient temperatures.
•
Best results will be obtained if installed and maintained
according to the following recommendations.
• Luminaire configurations are designed to operate
in ambient temperatures ranging from -40°C to 40°C
or -40°C to 50°C. See technical data sheet for
configuration specific ambient ratings.
Luminaire is
designed to be mounted horizontally with LEDs facing
down, as shown.
GE
Lighting
Installation Guide
GEH-6009B
imagination at work
SPECIFICATIONS
•
Weight: Maximum weight
ERS1: 20.4 - 24.5 lbs (9.25 - 11.11kg)
ERS2: 24.5 - 28.5 lbs (11.11 - 12.93kg)
•
Dimensions: L x W x H
ERS1: 21.3 in.
x
14.5 in.
x
5.4 in.
(542mm
x
368mm
x
136mm)
ERS2: 25.9 in.
x
14.5 in.
x
5.4 in.
(659mm
x
368mm
x
136mm)
•
IP Rating: Optical IP6
6
, Standard Electrical Enclosure:
UL 1598 Wet Location Rated
•
IEC Version Fixture Rating: IP44
•
Mounting Height: 27 - 40 ft. (8.2m - 12.2m)
•
EPA:
ERS1: 0.5 ft
2
(0.046m
2
)
ERS2: 0.7 ft
2
(0.065m
2
)
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Save these instructions for future use.
WARNING
Risk of electrical shock.
Disconnect power before servicing
or installing product.
CAUTION
Risk of injury.
Wear safety glasses and gloves during
installation and servicing.
WARNING
Risk of injury or damage.
Unit will fall if not installed
properly. Follow installation instructions.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
This Class [A] Lighting Equipment complies with
Canadian standard ICES-005[A] / NMB-005[A].
Note: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
