Laying out and Connecting Optical
1
Lay out Optical Fibers and Ethernet Cables
The following uses ove
Lead the optical fib
You can lay out op
a.
Lead the corru
the cabinet an
b.
Lay out the op
22
1
b.
Lay out the op
to the interface
If there is no routin
after putting the op
optical fiber into the
shown in the left fig
z
The number of optic
or 25 (in a closed corr
z
Do not bundle the o
communication betwe
z
The minimum bend
cm.
z
When laying out an
single-mode one and
2 Connecting Optical Fibers and Ethernet Ca
Do not look into the optical fiber outlet directly with your eyes
your eyes.
z
To connect the optical fiber to an optical interface with no op
the interface and push it until the module is fixed.
z
Before connecting the optical fiber, you need to remove the p
z
One Rx optical interface and one Tx optical interface form a
connected to an Rx optical interface and the other end to a Tx o
1
1
8
Insert the optical fiber into the optical module.
1
Fibers and Ethernet Cables
s
erhead cabling as an example:
ber through the corrugated pipe.
ptical fibers as required by observing the following principles:
ugated pipe to the routing hole for the signal cable at the top of
d fix the pipe.
ptical fiber along the optical fiber path on the cabinet and lead it
ptical fiber along the optical fiber path on the cabinet and lead it
e area through the corresponding routing trough.
g trough, you can lead the optical fiber leftward or rightward
ptical fiber horizontally with the interface, and then insert the
e optical interface, without obstructing other interfaces, as
gure.
cal fibers should be less than 60 (in an open corrugated pipe)
rugated pipe).
optical fibers too tightly. Otherwise, the quality of the
een devices is reduced.
d radius of the turnings of optical fibers should be larger than 4
nd connecting optical fibers, note the difference between a
a multi-mode one.
bles
. Otherwise, the laser emitted from optical fibers may injure
ptical module installed, you need to align the optical module to
protective caps of the optical module and optical connector.
connector pair. That is, one end of an optical fiber should be
optical interface.
2
2
8
2
Insert the Ethernet cable into the electrical interface.
