2.
Run:
mpls l2vpn
The MPLS L2VPN view is displayed.
3.
Run:
mpls l2vpn default martini
The system switches to the Martini mode.
NOTE
Before using the
mpls l2vpn default martini
command to set the behavior of the dynamic VC
signaling to non-Notification mode, you need to delete the configurations of VCs (including
PWE3 VCs and VPLS VCs) that support the Notification signaling.
4.
Run:
quit
Return to the system view.
5.
Run:
interface
interface-type
interface-number
The AC interface view is displayed.
6.
Run:
mpls l2vc
{
ip-address
|
pw-template
pw-template-name
}
*
vc-id
[
group-
id
group-id
|
tunnel-policy
policy-name
| [
control-word
|
no-control-
word
] | [
raw
|
tagged
] |
mtu
mtu-value
]
*
The master PW is configured.
NOTE
Before using a PW template to create a PW, you need to configure a PW template. For details,
refer to
6.3 Configuring the Attributes of a PW Template
7.
(Optional) Run:
mpls l2vc
{
ip-address
|
pw-template
pw-template-name
}
*
vc-id
[
group-
id
group-id
|
tunnel-policy
policy-name
| [
control-word
|
no-control-
word
] | [
raw
|
tagged
] |
mtu
mtu-value
]
*
secondary
The backup PW is configured.
NOTE
l
Both master and backup PWs need to be configured on the PE to which a CE is single-
homed. Only the master PW needs to be configured on the PE to which a CE is dual-homed.
l
Master and backup PWs must have different VC IDs.
l
The control word configuration on the primary and secondary PWs must be the same.
Otherwise, lots of packets will be lost after the primary/secondary PW switchover.
l
BGP PW
1.
.
2.
5.6.3 Configuring BGP/MPLS L2VPN
.
3.
.
NOTE
After this step, the system enters the MPLS-L2VPN instance view, and then you can perform
Step 4. Otherwise, you need to run the
mpls l2vpn
l2vpn-name
command to enter the MPLS-
L2VPN instance view.
Quidway S7700 Smart Routing Switch
Configuration Guide - VPN
5 VLL Configuration
Issue 01 (2011-07-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
479
