www.4GSource.net
20
2. Configuring Your Computer
Configure the network card for your computer, to enable the
computer to automatically obtain information such as the IP address
and the gateway.
3.5 Configuring the PPPoA mode
In the PPPoA mode, the HG520s uses the embedded PPP dial-up
software for dialing.
Configuring the PPPoA mode is similar to configuring the PPPoE
mode. The only difference is that you have to select
PPPoA
in the PVC
configuration mode to configure PPPoA and select
PPPoE
to configure
PPPoE. For details, refer to 3.4 "Configuring the PPPoE Mode."
3.6 Configuring the RFC2684B Mode
This section describes the process to configure the HG520s in the
RFC2684B mode and the process to configure your computer to
access the Internet through the HG520s.
3.6.1 Preparation
Table 3-4 shows the configuration for the RFC2684b mode.
Table 3-4 Configuration for the RFC2684B mode
Name
Configuration
PVC mode
Routing
Encapsulation RFC2684B
Default route
Enable
WAN IP address/subnet mask
There are two methods:
z
Obtain IP address automatically
z
Use the static IP address
VPI/VCI
Provided by the ISP
Multiplex
Provided by the ISP
