|
41
Temperature Switch TS 2-1000
40
| Function mode „Thermometer N1“
start mode
After all inputs have been made the mode is started by confirming this menu
point.
note n1:
input values for the temperature range from -99°C to +850°C
note n2:
the input mode can be left at all times by pressing the button
esc
note n3:
if a button is not pressed the duration of 10 seconds in the
programming mode, the device will automatically return to the
function mode without saving the values that have already been
input.
8 FuncTIOn mOde “heaTIng” and “cOOlIng”
The relay ALARM is switched ON if the measured temperature is higher or
equal to T ALARM Max or lower or equal to T ALARM Min. The relay ALARM is
switched OFF if the measured temperature is higher than T ALARM Min or lower
than T ALARM Max.
8.1 FuncTIOn mOde “heaTIng“
The function “Heating” is active if the programmed
switching ON
temperature is lower than the switching OFF temperature
.
The relay is switched
OFF if the measured temperature
is equal or higher than T OFF.
The relay is switched
ON if the measured temperature
is lower or equal to T EIN.
The relay ALARM is switched ON
if the measured temperature
is higher or equal to T ALARM Max or lower or equal to T ALARM Min.
8.2 FuncTIOn mOde „cOOlIng“
The function “Cooling” is active if the programmed
switching ON temperature is higher than the switching OFF temperature.
The relay is switched
ON if the measured temperature
is equal or higher than T EIN.
The relay is switched
OFF if the measured temperature
is lower or equal to T AUS.
T1 alarm min
In this menu you can enter a minimum temperature at which an alarm will be
sounded. Press button
Ok
. The value can now be changed with the buttons
pq
. The selection is confirmed by pressing the button “
Ok
” and the device will
move to the next menu point.
T1 alarm max
In this menu you can enter a maximum temperature at which an alarm will be
sounded. Press button
Ok
. The value can now be changed with the buttons
pq
. The selection is confirmed by pressing the button “
Ok
” and the device will
move to the next menu point.
T1 alarm delay
In this menu you can enter a time between 0 and 8 hours. The switching of the
alarm relay N1 will be delayed by the entered time. Press button
Ok
. The value
can be changed with the buttons
pq
. The selection is confirmed by pressing
the button “OK” and the device will move to the next menu point.
relay status at malfunction
In this menu you can define the action of the relay REL1 and ALARM 1 if a mal
-
function is detected. Options are:
1.
ON
2.
OFF
3.
No changes to existing status.
The value can be changed with the buttons
pq
. The selection is confirmed
by pressing the button “
Ok
” and the device will move to the next menu point.
piezo
In this menu you can define the action of the piezo speaker if a malfunction is
detected. Options are:
1.
ON
2.
OFF
The value can be changed with the buttons
pq
. The selection is confirmed
by pressing the button “
Ok
” and the device will move to the next menu point.
