Im Martelacker 12 – D-79588 Efringen-Kirchen – Phone 0 76 28 - 91 11- 0 – Fax 0 76 28 - 91 11-90
E-Mail: [email protected] – Web: www.hs-technik.com
- 64 -
If you want to execute a job later or you have
scanned the wrong barcode, you can cancel this
after the release.
To do this, hold down the display button for ap-
prox. 3 seconds. The cancel symbol will appear.
Confi rm this by pressing the small left side display
button.
If the connection to the controller (process controls) via wireless connection
through an access point is interrupted and a job has already been released
in the screwdriver, it should be further processed if possible. After completing
the job, the screwdriver will try to send the screwing process results. If the
connection to the process controls cannot be restored, the screwing process
results must be manually secured (read out the tool using the Toolmanager
software and saved).
Then, after removing the battery, the emergency strategy can be used to
continue working.
To do this, hold down the trigger and slide the battery back on. After approx.
3 seconds, the "set-up symbol" will appear on the display. You can now
release the trigger and will be in the set-up menu.
By pressing the yellow button, you can go to the next menu point. By
pressing the trigger, you can select a menu point. Using the smaller, left
button, confi rm your selection; with the right button, cancel the selection.
4.3.0. CANCEL JOB
4.3.0. EMERGENCY STRATEGY
Summary of Contents for PROG-3
Page 82: ...www hs technik com ...
Page 83: ...www hs technik com ...
