VDPLW800_v2
VELLEMAN
6
Detailed DMX Values per Channel
3-channel mode
Channel
Function
From To
Description
CHANNEL 1
Red
0
255 Red LEDs from OFF to full on
CHANNEL 2
Green
0
255 Green LEDs from OFF to full on
CHANNEL 3
Blue
0
255 Blue LEDs from OFF to full on
6-channel mode
Channel
Function
From To
Description
0
4 No function
5
5 Full on
6
247 Special effects (LEDs change each two DMX values)
CHANNEL 1
Special effects
248 255 Full on
CHANNEL 2
Red
0
255 Red LEDs from OFF to full on
CHANNEL 3
Green
0
255 Green LEDs from OFF to full on
CHANNEL 4
Blue
0
255 Blue LEDs from OFF to full on
0
4 No function
5
253 Strobe from fast to slow
CHANNEL 5
Strobe
254 255 Full on
0
4 No function
5
30 Built-in program 1
31
60 Built-in program 2
61
90 Built-in program 3
91
120 Built-in program 4
121 150 Built-in program 5
151 180 Built-in program 6
181 210 Built-in program 7
211 240 Built-in program 8
CHANNEL 6
Built-in programs
241 255 Sound activation mode
Projector DMX start address selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to “listen” to the DMX controller. Enter the correct
number and read it from the display located on the base of the
VDPLW800
.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the
VDPLW800
s will “listen” to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you set
different addresses, each device will “listen” to a separate channel number. Changing the settings of one channel will
only affect the device in question.
In the case of the 6-channel
VDPLW800
, you will have to set the start address of the first
VDPLW800
to 1, the
second to 7 (1 + 6), the third to 13 (7 + 6) and so on.
6. Cleaning and Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
Summary of Contents for VDPLW800
Page 2: ...VDPLW800_v2 VELLEMAN 2...
