Cross Trainer XTR2
3
Assembling your XTR2
5. Install cylindrical bases
(#2 for front. #3 for rear)
to the main frame (#1).
Notice that the front base
(#2) has wheels for
moving your XTR2.
For each base, use two
3/8”X 2 1/4” carriage
bolts (#46) and two
3/8”acom nuts (#47). See
(
#
47) Flg.1.
Steps 6 through 8
describe the assembly for
the pedals any coupler
bars. Once assembly for
one side is complete,
repeat these steps for the
other side before you
proceed to attach the
handlebars.
Notice the coupler bar for
each side is different (#4
for right side, #5 for left
side). A coupler bar is at
the correct side of the
XTR2 when its horizontal
pivot tube, which is
welded at the top of the
coupler bar, faces the
rear of the machine as
seen from the user. See
Fig.2.
6. Insert a handle bar shaft
(#12A) through the
coupler bar of right & Left
both side and frame.
The handle bar shaft
shown in Page 2.
Then put D sharp washer
and Spring washer on
both side and tighten the
hinge screw.