4-22 AlphaServer 300 User’s Guide
Storage Bay
This section describes how to install a drive in the outer-bay lower position. You can also
use this bay for another 5.25-inch half-size drive, such as the TZK11 tape drive.
________________________ CAUTION ___________________________
Do not install a SCSI hard disk in this bay. This can cause system overheating.
____________________________________________________________
To install a drive, follow these steps:
1.
Insert a screwdriver
c
through the access port and gently pry the blank panel
d
out,
as Figure 4-17 shows.
MLO-011116
1
2
Figure 4-17 Removing Storage Bay Blank Panel
2.
For the desired configuration, use the drive jumpers to set the SCSI ID and proper
mode.
)
Refer to your drive's installation guide for specific information.
3.
If the storage option you are adding is the last one on the SCSI cable, make sure that
the internal SCSI termination is moved from the previous SCSI option to the last
option.
