HP VMA Series, Installation And Service Manual

Page: 72 / 300

Chapter 4 - Configuring the Array
72
VMA-series Memory Array Installation and Service Guide HP-AM456-9002A Rev 01
Setting the IP Address for the Syslog Host
Send system log messages to a host attached to the Memory Array via the
Ethernet port. This host must have syslog configured correctly. See your host’s
syslog documentation for instructions.
Note:
From the CLI prompt, use the
ping
command to verify the connection
between the Memory Array and the remote syslog host.
To set the IP address of the host to which the system log messages will be sent:
1.
Log into the Memory Array.
2.
Navigate to the Syslog context level. At the root prompt, type:
3.
At the Syslog context prompt, type:
Where:
4.
To commit the change made to the IP address, from the
System
context
level command prompt, type:
Or, from the Syslog context level, type:
Or
Determining the Status of the System Log
Service
Display the status of the service that sends the system log messages to a host.
1.
Log into the Memory Array.
2.
Navigate to the Syslog context level. At the root prompt, type:
3.
At the Syslog context prompt, type:
context system logging syslog
set host <ip_address>
ip_address
Specifies the IP address of the syslog host to which
the system log messages will be sent.
save config
top
save config
save system config
context system logging syslog
show service