Chapter 7 - Linux Drivers
130
VMA-series Memory Array Installation and Service Guide
HP-AM456-9002A Rev 01
3.
At the Command prompt, type
n
to create a new partition:
Where
n
specifies to create a new partition.
The command displays information similar to the following:
4.
Next, at the Command prompt, create the new partition by typing:
Where
p
creates a primary partition.
The command displays information similar to the following:
•
Specify the partition number if you will be creating more than one
partition on the device, or accept the default value of
1
by pressing the
Enter key. The default value to set the beginning cylinder to is
1
, which
can be changed if needed.
•
Specify the size of the block device or accept the default value of the
available memory by pressing the Enter key.
5.
Next, at the Command prompt, write the new partition by typing:
Where
w
writes the partition table to disk and exit.
n
Command (m for help):
n
Command action
e extended
p primary partition (1-4)
p
Command action
e extended
p primary partition (1-4)
p
Partition number (1-4):
1
First cylinder (1-16709, default 1):
Using default value 1
Last cylinder or +size or +sizeM or +sizeK (1-16709, default
16709): 8000
w
Summary of Contents for VMA Series
Page 4: ...4 VMA series Memory Array Installation and Service Guide HP AM456 9002A Rev 01 ...
Page 22: ......
Page 38: ......
Page 116: ......
