HP VMA SAN, Installation And Configuration Manual

Page: 43 / 83

AM456-9025A HP VMA SAN Gateway Installation and Configuration Guide 43
Completing the Replacement
Go to the section that represents your configuration, and follow the steps to complete the
replacement:
•
Both Nodes Running G5.1.0 on page 41
•
G5.1.0 on mg-b and G5.2.0 or Higher on mg-a on page 41
•
Both Nodes Running G5.2.0 or Higher on page 41
Both Nodes Running G5.1.0
If both your existing Memory Gateway node (mg-b) and the newly replaced Gateway node are both
running software version G5.1.0, complete the following steps:
1.
While logged in to the newly replaced Memory Gateway node, enter the following command:
2.
Watch the command line to ensure that the prompt changes to
standby
.
G5.1.0 on mg-b and G5.2.0 or Higher on mg-a
If your existing Memory Gateway node (mg-b) is running software version G5.1.0 and the newly
replaced Gateway node is running G5.2.0 or higher, contact HP Customer Support.
Both Nodes Running G5.2.0 or Higher
If both your existing Memory Gateway node (mg-b) and the newly replaced Gateway node are both
running software version G5.2.0, complete the following steps:
1.
While logged in to the newly replaced Memory Gateway node, enter the following command at the
prompt:
2.
Next, enter this command after the prompt:
The prompt changes to look like the following:
mg-a [violin: master]# cluster id <same_id_as_mg-b>
mg-a [violin: master]# no cluster enable
mg-a [violin: master]# fms enable
mg-a [FRU: searching](config)#