HP VMA SAN, Installation And Configuration Manual

Page: 26 / 83

26 HP VMA SAN Gateway Installation and Configuration Guide AM456-9025A
The fastest way to configure a master or standalone HP VMA SAN Gateway node is with the setup
configuration wizard.
Note:
Interface bonding and cluster VLAN configuration are not included in the configuration
wizard setup. For initial cluster setup, or for single-Ethernet cable to Gateway configurations, you
can specify the eth1 interface as the “Public interface name” and “Cluster interface name” in the
wizard. Then configuration of the interface bonding and VLAN using the CLI will be done in the
Redundant Gateway Pairing Process Guide
.
To configure the master or standalone SAN Gateway node, do the following:
1.
Log in to the SAN Gateway as admin, as described in Logging in to the SAN Gateway on page
22.
2.
The configuration wizard prompts you for an initial configuration of the HP VMA SAN
Gateway. Enter Yes (the first letter must be capitalized).
You are prompted to answer a series of configuration questions. The responses given for each
question will configure the initial HP VMA SAN Gateway, which becomes the master node.
3.
After the first question, enter Yes .
Entering Yes defines the current HP VMA SAN Gateway as the master node, whether for a
single node cluster (standalone) or a redundant gateway pair. For information on configuring a
redundant gateway pair, see the
Redundant Gateway Pairing Process Guide
at http://www.hp.com/
go/vma-docs.
Do you want to use the wizard for initial configuration?
Yes
Step 1: Configure as master/stand-alone? [yes]