Related reference
Storage controller enclosure controller module status LEDs
on page 17
Completing the controller module replacement
In the StoreVirtual Management Console:
Procedure
1.
Navigate to the
Storage Controllers
section to verify the controller module status. The controller status is
listed next to the controller name in the left list pane.
2.
Use
Restore peer
to reassociate the two storage controllers. The
Restore peer
function will be required in
most controller replacements, specifically if the failed controller had completed initial configuration.
NOTE:
If the failed controller has not been configured, the Restore peer function is only required if there is a
version mismatch between the failed controller and the replacement controller.
3.
Fail back the storage controller.
NOTE:
You can locate failback in the StoreVirtual Management Console
Storage Systems
pane.
See the
HPE StoreVirtual 3200 Management Console Online Help
for more information.
Replacing a drive enclosure I/O module
Verify I/O module failure
Before replacing an I/O module, verify its status using one of the following methods:
• Ensure that the I/O module has failed by verifying the I/O module status LEDs. For the location of the I/O
module LEDs, see
HPE StoreVirtual 3000 drive enclosure
on page 12. For information on interpreting
the status, see "Related reference".
• Verify the I/O module status from the hardware report in the StoreVirtual Management Console.
Related reference
Status LED descriptions
on page 15
Removing an I/O module
Procedure
1.
Unplug all cables from the I/O module.
a.
Do not unplug the power cables if performing a hot or warm swap.
b.
If SAS cables are being used to connect enclosures and you must disconnect from the affected
enclosure, be sure that you do not remove both SAS cables at the same time. At least one SAS cable
must be connected to the component to ensure access continues to the drives in the enclosure.
2.
Loosen the captive retaining thumbscrew (1), and swing out the I/O module handle (2).
58
Completing the controller module replacement
