HP StorageWorks SSL1016, Reference Manual

Page: 66 / 160

Tape Cartridge Usage
66 SSL1016 Tape Autoloader Reference Guide
c. For DLTtapes: hold the tape cartridge so that the end that is inserted into
the tape drive is facing you. On the left side of the tape cartridge you
should see a small plastic tab. This is the left reel lock and can break if the
cartridge is dropped. If you cannot see the tab, do not use the cartridge.
d. For DLTtapes: Do not use the cartridge if you see any of the following
conditions:
Figure 48: DLTtape faulty leader situations
1
Swallowed leader - leader is completely wound around into the cartridge, leaving no loop
for the buckling link to catch.
2
Torn leader loop - if the loop gets ripped to create an opening, the buckling link will fail to
grab the loop and thus not transport the tape into the drive.
3
Creased leader loop - the loop is stuck and the cartridge leader cannot unwind into the
drive. As the drive leader’s buckling link engages the cartridge leader loop, it can detach the
loop and drag it into the drive causing damage.
e. For DLTtapes: look at the bottom of the tape cartridge. The bottom reel
lock is located in the lower right corner and can break if the cartridge is
dropped. If you cannot see the tab, do not use the cartridge.
Note: On the DLTtape cartridge, the reel lock is white and easy to see.
5. Check for proper operation of the tape cartridge write-protect switch.
1 2
3