HP StorageWorks 8/24 - SAN Switch, Hardware Reference Manual

Page: 40 / 110

4. Assemble the outer rails:
a. Attach the left outer rail and the right outer rail to the rear mounting brackets, using two
1/4-20 hex nuts with captive star lock-washers attached loosely, as shown in
Figure 13 . Do
not tighten the nuts.
Figure 13 Installing the outer rails (HP 10000 series racks)
b. Depending on the rack you are using, complete one of the following tasks:
• For HP 10000 series racks, install two #10-32 x 1/2-inch Phillips pan-head screws with
captive star lock-washers and two #10 adapter washers in the upper and lower hole
locations of the right rail. Then install two #10-32 x 1/2-inch Phillips pan-head screws
with captive star lock-washers and two #10 adapter washers in the upper and lower
hole locations of the left rail. See
Figure 14 .
Figure 14 Assembling the outer rails (HP 10000 series racks)
Installing and configuring an 8-Gb SAN Switch 40