Supplementary Procedures
6-6
Hewlett-Packard VPN Server Appliance SA3110/SA3150/SA3400/SA3450 Installation Guide
Using the Copy Command (TFTP)
Using the Copy Command (TFTP)
Using the Copy Command (TFTP)
Using the Copy Command (TFTP)
The TFTP (Trivial File Transfer Protocol)
copy
command
transfers a file to or from a TFTP server. The
copy
command
can be used to upgrade firmware. Also, the
copy
command can
be used to back up or restore configuration files.
This transfer retains passwords and displays them in clear text.
This section tells you how to copy new or modified
configuration files from the computer running the TFTP server
to the VPN device.
Steps
Steps
Steps
Steps
To use the TFTP
copy
command:
1.
Write or edit the isbr.exe and lrvg.exe files in a plain text
editor, such as Notepad.
2.
Ensure the source computer has a TFTP daemon running.
3.
Install the isbr.exe and lrvg.exe files on your TFTP server.
4.
Open the Console window.
See "Preparing to Configure a New VPN device" in Chapter 3.
5.
In the Console window, enter:
copy
from <ip address of the source computer with the
TFTP daemon running> isbr.exe
The isbr.exe file is transferred immediately from the
computer to the VPN device.
Note:
Note:
Note:
Note: If you copy a new version of an existing file to a VPN
device, the device overwrites the existing file without any
warning prompt.
6.
In the Console window, enter:
copy
from <ip address of the source computer with the
TFTP daemon running> lrvg.exe
The lrvg.exe file is transferred immediately from the
computer to the VPN device.
7.
From the Console window or the VPN Manager window,
issue a
reboot
command to the device, then press Enter.
You are prompted to confirm your
reboot
command.
8.
To confirm your
reboot
command, enter
Y
.
Summary of Contents for sa3110
Page 2: ...ii ...
