Removal and replacement procedures 45
c.
Finish the installation by completely tightening the screws in the same sequence.
4.
Install the system air baffle.
5.
If removed, install the PCI air baffle.
6.
Install the access panel.
7.
Return the server to an upright position.
8.
Lock the front bezel.
9.
Connect each power cord to the server.
10.
Connect each power cord to the power source.
11.
Power up the server (on page
25
).
Processor
CAUTION:
To avoid damage to the processor:
•
Handle the processor only by the edges.
•
Do not touch the bottom of the processor, especially the contact area.
IMPORTANT:
If installing a processor with a faster speed, update the system ROM before
installing the processor.
To remove the component:
1.
Power down the server (on page
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Unlock the front bezel (on page
4.
Place the server on its side.
5.
Remove the access panel ("
6.
If installed, remove the PCI air baffle ("
7.
Remove the system air baffle ("
8.
Remove the heatsink ("
