HP ProLiant ML350e Gen8, Maintenance And Service Manual

Page: 28 / 91

Removal and replacement procedures 28
To replace the component, reverse the removal procedure.
System air baffle
To remove the component:
1.
Power down the server (on page 24 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Unlock the front bezel (on page 25 ).
4.
Place the server on its side.
5.
Remove the access panel (" Access panel " on page 26 ).
6.
If installed, remove the PCI air baffle (" PCI air baffle " on page 27 ).
7.
Remove the system air baffle.
To replace the component, reverse the removal procedure.
Front USB module
To remove the component:
1.
Power down the server (on page 24 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Remove the front bezel (on page 26 ).
4.
Place the server on its side.
5.
Remove the access panel (" Access panel " on page 26 ).
6.
If installed, remove the PCI air baffle (" PCI air baffle " on page 27 ).
7.
Remove the system air baffle (" System air baffle " on page 28 ).