Hardware options installation 53
8.
Install the dedicated iLO management module.
9.
Install the rear system fan.
10.
Install any removed expansion board.
11.
Install the air baffle (on page
22
).
12.
Install the access panel (on page
21
).
13.
Lock the tower bezel.
14.
Connect each power cord to the server.
15.
Connect each power cord to the power source.
16.
Power up the server (on page
18
).
Enabling the dedicated iLO management port
The onboard NIC 1/shared iLO connector is set as the default system iLO port.
To enable the installed dedicated iLO module:
1.
During the server startup sequence after module installation, to access iLO RBSU, press the
F8
key.
2.
Select the
Network
menu.
3.
Click the
Network Interface Adapter
field.
4.
To change the setting to
ON
, press the spacebar.
5.
To save the new settings, press the
F10
key.
6.
Select the
File
menu, and then to close iLO RBSU, click
Exit
.
7.
To confirm exiting iLO RBSU, click
OK
. The server automatically reboots.
IMPORTANT:
If the iLO RBSU settings are reset to the default values, access to the machine will be
lost. Access the physical machine, and then set the
Network Interface Adapter
field to
ON
.