Hardware options installation 48
7.
Align the notch on the bottom edge of the memory module with the keyed surface of the DIMM slot, and
then fully press the memory module into the slot until the latches snap back into place.
8.
Install the air baffle (on page
19
).
9.
Install the access panel (on page
17
).
10.
Do one of the following:
o
Slide the server into the rack.
o
Install the server into the rack ("
Installing the server into the rack
" on page
26
).
11.
Connect the peripheral devices to the server.
12.
Connect the power cord to the server.
13.
Connect the power cord to the power source.
14.
Power up the server (on page
14
).
15.
After installing the DIMMs, to configure memory protection mode, use RBSU ("
HP ROM-Based Setup
Utility
" on page
71
).
Expansion board options
The server has both full-height and low-profile expansion slots for controller option installation ("
PCIe riser
board slot definitions
" on page
8
). Controller options with internal cable connections should be installed in
the full-height riser board slot 1.
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (
http://www.hp.com/go/qs
).
CAUTION:
To prevent improper cooling and thermal damage, do not operate the server unless
all expansion slots have either an expansion slot cover or an expansion board installed.
To install the component:
1.
Power down the server (on page
14
).
2.
Remove the power from the server:
a.
Disconnect the power cord from the power source.
Summary of Contents for ProLiant DL320e Gen8 v2
Page 65: ...Cabling 65 Front I O board cabling ...
Page 94: ...Support and other resources 94 ...
